Generac 0C3025 Oil Pressure Switch 10 PSI 1/4"-18 Thread Normally Closed

  • Sale
  • $34.64
  • Regular price $37.45

This oil pressure switch has been replaced by 0C30250SRV found here:

Generac 0C30250SRV Oil Pressure Switch Replacement For 0G6820 10 PSI 1/4"-18 Thread Normally Closed

If you order this switch you will receive the switch kit listed above!  Please note that the switch works exactly the same and was updated by Generac.

Generac 0C3025 Oil Pressure Switch.  Has 10 PSI oil pressure actuation.  Switch is normally closed (N.C.) meaning when oil pressure is applied at 10 PSI or more, the switch will open and allow the generator to run.  Has 1/4"-18 threads.  Was used on many Air Cooled models from the later 1990's until around 2010 when they switched to the same sensor, but with push-on type connectors (0G6820).  Either will work, but you would need to cut off the connectors and crimp on your own ring style for this sensor to work.  Should be installed using thread sealant (not included).  Use extreme caution when tightening this sensor into the block as the threads are tapered and will crack the block if over-tightened.  This will result in the engine block needing replacement!

Generac replacement parts will also usually fit the following Generac branded generators: Honeywell, Guardian, Siemens, Carrier, Watchdog, Centurion, & Bryant.


If you need Generac generator troubleshooting support, please visit our interactive forum