Generac 10000014761 Auxiliary Shutdown Switch Kit

  • Sale
  • $24.99
  • Regular price $26.99


Generac 10000014761 Auxiliary Shutdown Switch Kit.  The Auxiliary Shutdown Kit provides the components needed to meet 2017 NEC - 445.18 Disconnecting Means and Shutdown of Prime Mover.

Please note that this kit requires firmware version 1.20 or higher to be installed on Evolution 1.0 controllers for it to work.  This kit DOES NOT provide the firmware which must be installed by a local Generac dealer.

This kit is designed to work with the following Generac products: 

  • 9kW - 22kW Guardian Series products
  • 15kW EcoGen product
  • 20kW Synergy product
  • 20kW three-phase product
  • 22kW – 60kW Protector gas products
  • 15kW – 50kW Protector diesel products

Kit will cause an Aux Shutdown 2800 Alarm when either switch is pressed to off, causing the unit to shutdown.  You must then open the lid, reset the switch and then clear the alarm on the controller to re-start the unit or place it back into Auto mode.

To meet NEC 2017 requirements, units 15kW and up in size must have 2 switches installed (included with this kit) and units 14kW and below only need 1 switch installed outside of the unit.  All units can have 2 switches installed if desired.

Generac replacement parts will also usually fit the following Generac branded generators: Honeywell, Guardian, Siemens, Carrier, Watchdog, Centurion, Eaton & Bryant.

 

If you need Generac generator troubleshooting support, please visit our interactive forum